Fi-Clor 1ltr Phosphate Remover
1ltr Fi-Clor Phosphate Remover
1.Measure the phosphate level (ppb) in the water using a Phosphate Test kit.
2.75ml will remove 100ppb of phosphate in 50m3 (11,000 gals). Quantity of product required (ml) = 0.015 x volume of pool (m3) x phosphate level (ppb)
3.Backwash the filter.
4.With the filter running, add the product directly to the pool at the inlets.
5.Run filtration for at least 24 hrs, check filter pressure and if needed backwash the filter again.
6.After 48 hrs, measure the phosphate level again using a Phosphate Test kit and if necessary add further phosphate remover following the instructions above. Warning: Do not use together with other products. May release dangerous gases (chlorine). Precautions: Never mix chemicals, except by dosing into the pool separately and at different times. Never add chemicals to the water when bathers are in the pool. Store in a cool, dry, well ventilated, secure place away from oxidising and reducing agents, eg, petrol, oil, solvents and organic materials; ammonia, fertiliser and nitrogen compounds; strong acids and alkalis. Avoid direct contact with pool chemicals. Should there be skin contact with chemicals, wash thoroughly. Disposal When empty and providing it has been rinsed out on the pool. this container may be disposed of via household recycling.